Our rabbits live in a colony, and they have been using metal bowls for their water. However they always tip over their water bowls before everyone has had a chance to have a drink. I decided that it was time to make an automatic waterer for the rabbits and another one the same for the chickens.
Automatic watering systems take the worry out of watering the animals. An auto waterer can last for several days and it keeps rabbits and chickens from making the water dirty or tipping it out.
To make this automatic waterer I used a few things that I had laying around, but you could easily replace these with things you have or can make.
I have based the whole automatic waterer around a metal barstool frame that we had laying out in the paddock. You could easily make a stand that is similar with pallet wood.
The 10L plastic bucket with a lid was one that I had in the laundry already. You could probably get yourself a free icing bucket from a local bakery.
I had half a tube of silicone in the garage from doing odd jobs around the house.
For the netting that I discovered was required AFTER they chewed all the first lot of hose up, I used some welded mesh that was left over from building their house. Every homestead has chicken wire or wire mesh laying around, find your stash!
Now I bought the lubbing cups (the bowl water thingies) as my bunnies don’t know how to work the water nipples (yet) but I have discovered that they have chewed them quite a lot. So for chickens the cups are great, but for rabbits, I would stick with the metal nipples.
How to build an automatic watering system for rabbits and chickens.
Step one is to drill a hole in the side of the bucket. It needs to be about 1 inch up from the bottom of the bucket to stop the things that will somehow end up in water from blocking the tube. It needs to be the right size so that one of your T joiners only just fits through it with a little bit of force.
Step two I inserted a T connection into the hole and made part of it point up and the second to point out straight. The part that points up is where I connected a length of clear hose so I can tell how full the bucket is without removing the lid.
Step three Silicone around the inside of the bucket where the T connection goes in, and I used it as glue to hold the water level hose to the bucket.
The lubbing cup needed one end to be sealed off with silicone as I am not connecting them in series.
Step four I screwed the nipple and cup to the stool legs. You could make a frame with timber, even from pallet wood. This stool just happens to fit my bucket in just perfectly. I did pre-drill the holes in the metal legs.
Step five is to attach all the hose to the connectors.
After 24 hours for the silicone to set, I tested that all the joints and connections worked with actual water in it. The top of the lubbing cup has a screw on it (green in this image) that you can alter to stop the water overflowing the cup.
Now I have also wrapped all the sides in netting, very securely. This is to stop the rabbits from being able to access the hose, as my mark I version was chewed out in under 24 hours!
**UPDATE** The rabbits chewed out the lubbing cup within days. The chickens however are great with them. The rabbits now just have the metal rabbit waterer attachment which works great. Just don’t let them access the hose!
Do you have an automatic watering system setup? Tell me about it in the comments below!
Please Pin and Share with Friends and Family.